[Dxspider-support] Inactivity Timeout

[Jim Wilcox]

Looking at the output from the screen, I see that DXSpider seemes to be
restarting every time it fails to connect to my link node.  Any ideas on
this?

Jim
KE4IHI


-----Original Message-----
From: dxspider-support-bounces at dxcluster.org
[mailto:dxspider-support-bounces at dxcluster.org]On Behalf Of Dirk Koopman
Sent: Sunday, May 25, 2003 1:59 PM
To: The DXSpider Support list
Subject: Re: [Dxspider-support] Inactivity Timeout



The inactivity timer should send a plain prompt every 11 minutes. This
is an output inactivity timer. A lack of input will not cause the node
to disconnect. The node should send a prompt if there is no input or
output and the interval is normally short enough to keep things alive.

On Sun, 2003-05-25 at 18:34, Jim Wilcox wrote:
> Is there any way to disable the inactivity timeout on the cluster.  My
users
> keep getting logged off after a while.  CLX has a setting called set/alive
> that allows them to stay connected.  This doesn't seem to work with
> DXSpider.  Any suggestions.
>
> Jim
> KE4IHI
>
> --------------------------------------------------------------------------
--
> ----------------
> Jim Wilcox
> IHS Software, Inc.
> If God is your co-pilot... trade seats!
>
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support
--
Please Note: Some Quantum Physics Theories Suggest That When the
Consumer Is Not Directly Observing This Product, It May Cease to
Exist or Will Exist Only in a Vague and Undetermined State.



_______________________________________________
Dxspider-support mailing list
Dxspider-support at dxcluster.org
http://www.tobit.co.uk/mailman/listinfo/dxspider-support