[Dxspider-support] node_default filter

[David Spoelstra]

Steve is correct.  This is the way to do it.
-David, N9KT

----- Original Message ----- 
From: "Stephen J. Carroll" <scarroll at mchsi.com>
To: "The DXSpider Support list" <dxspider-support at dxcluster.org>
Sent: Wednesday, December 08, 2004 3:42 PM
Subject: Re: [Dxspider-support] node_default filter


> Tom,
>
> I have filters setup to accept only Ws from my forwarding partners. To fix 
> your problem type:
>
> acc/spot node_default input by_dxcc k,ve
>
> That should fix it. Disconnect/re-connect after changes are made (might 
> not be necessary, but I do it here).
>
> Good luck.
> 73, Steve - K2SC
>
> ----- Original Message ----- 
> From: "Tom Vavra" <wb8zrl at avalon.net>
> To: "DXSpider" <Dxspider-support at dxcluster.org>
> Sent: Wednesday, December 08, 2004 8:21 AM
> Subject: [Dxspider-support] node_default filter
>
>
>> The node I normally connect to sends me only spots from Ws and VEs. 
>> However
>> the node I connect to when I cannot connect to the normal node sends me
>> everything.  I tried to filter them by
>>
>> reject/spot node_default not by_dxcc 226,197
>>
>> Everything seems to pass right through.  I tried negating it into an
>> accept/spot filter but that doesnt work either.  Am I doing this right??
>>
>>    Tom  WB8ZRL
>>
>>
>> _______________________________________________
>> Dxspider-support mailing list
>> Dxspider-support at dxcluster.org
>> http://www.tobit.co.uk/mailman/listinfo/dxspider-support
>>
>>
>
>
>
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support
>