[Dxspider-support] Unset/isolate not working
Bob Nielsen
nielsen at oz.net
Thu May 13 16:00:31 BST 2004
I'm connecting to him, rather than the other way around
On Thu, May 13, 2004 at 11:51:06AM +0000, Eric Carling wrote:
> For what its worth, in case it helps, I just tested set and unset/isolate
> with a local AR-Cluster node and it works perfectly. So its not a functional
> problem with DXSpider. Did you break the link with the ARC node before
> removing the isolation? Has the ARC sysop used his Node Connect
> Configuration screen to execute a remove -ext command?
>
> -------Original Message-------
>
> From: The DXSpider Support list
> Date: 13/05/2004 11:20:11
> To: The DXSpider Support list
> Subject: Re: [Dxspider-support] Unset/isolate not working
>
> I don't believe so (he asked me to remove the isolation so he could
> receive spots from me). It is an AR-Cluster node.
>
> On Thu, May 13, 2004 at 11:53:22AM +0100, Dirk Koopman wrote:
> > Has he got the node isolated at his end or has he/you got some route
> > filtering enabled?
> >
> > On Thu, 2004-05-13 at 11:46, Bob Nielsen wrote:
> > > I had a node connection which was isolated. I wanted to change this so
> > > I issued the unset/isolate command, but it still acts as if the node
> > > were isolated. sh/c doesn't show other nodes connected to that one and
> > > only shows the number of users on the node. The other node only shows
> > > my node as connected without any information on other nodes connected
> > > to mine, nor does it show my users. sh/isolate returns "0 records".
> > >
> > > Is there something else I need to do to get this connection to work
> > > correctly?
> > >
> > > Bob, N7XY
> > >
>
More information about the Dxspider-support
mailing list