[Dxspider-support] red Ha t9.0

[Bob]

Ok I will have a look . Just trying to get all the info I can now . I am a
windows use not a red hat . I will have a look and get all the note's and
sit down one night with a Big cup of Tea  and have a try . thanks  Bob
kc2cwt

-----Original Message-----
From: dxspider-support-bounces at dxcluster.org
[mailto:dxspider-support-bounces at dxcluster.org]On Behalf Of Bob Nielsen
Sent: Sunday, October 31, 2004 8:50 AM
To: dxspider-support at dxcluster.org
Subject: Re: [Dxspider-support] red Ha t9.0

That's probably about the minimum which would work with both IRLP and
spider, if neither is overly busy.  I ran spider for a while with a P133
(32 MB) and it was a bit sluggish (probably using swap a lot), but I'm
running a 1.2 GHz Celeron with 320MB after what the video uses and it
coasts.  With 9 users currently (3 r.f., 6 internet), the node is quite
busy right now (contest) but spider is using a total of less than one
percent of the CPU and 10 percent of the memory.

Use the ax25 and mkiss modules in the kernel.  This might require
compiling your own kernel, if Red Hat doesn't include these modules.
See the spider installation manual for information on setting this
up--it's a lot easier to follow than the AX25-HOWTO.

Bob, N7XY

On Sun, Oct 31, 2004 at 08:58:50AM -0500, Bob wrote:
> It's a P 3 @ 300 with 256 m this should work  I think . Now what would I
use
> for the rf link . Now using the agw packet engine .
> Thanks Bob kc2cwt
>
> -----Original Message-----
> From: dxspider-support-bounces at dxcluster.org
> [mailto:dxspider-support-bounces at dxcluster.org]On Behalf Of Dirk Koopman
> Sent: Sunday, October 31, 2004 5:23 AM
> To: Dxspider-Support
> Subject: Re: [Dxspider-support] red Ha t9.0
>
> The short answer is yes, but you need to check that the IRLP on it
> doesn't take all the cpu. It all depends on what speed the cpu is.
>
> Dirk
>
> On Sat, 2004-10-30 at 19:41 -0400, Bob wrote:
> > I Am looking for sum info . I have a red hat box running IRLP on it .
> Could
> > I have dxspider and IRLP running at the same time .
> > Trying to cut down on sum cpu's . I have a dxspider node under windows .
> > Thanks Bob kc2cwt
> >

_______________________________________________
Dxspider-support mailing list
Dxspider-support at dxcluster.org
http://www.tobit.co.uk/mailman/listinfo/dxspider-support