[Dxspider-support] IO::Socket::INET: Address already in use

[Eric Carling]

Of possible relevance, though whether this is the reason I do not know, is 
that Norton Internet Security blocks port 7300 by default. This port is of 
one several blocked by one of the pre-defined rules against internet 
attacks, being listed under 'Netmonitor Trojan Horse'. I removed the 
blocking to maintain the standard port access to DX Spider and it would be a 
lot better for users, just in my opinion, if any DX Spider could be reached 
on one standardised port ie 7300.


----- Original Message ----- 
From: "Dirk Koopman" <djk at tobit.co.uk>
To: "The DXSpider Support list" <dxspider-support at dxcluster.org>
Sent: Monday, June 27, 2005 8:39 AM
Subject: Re: [Dxspider-support] IO::Socket::INET: Address already in use


> On Mon, 2005-06-27 at 18:10 +1000, brucebel wrote:
>> >
>> >
>> >
>> >_______________________________________________
>> >Dxspider-support mailing list
>> >Dxspider-support at dxcluster.org
>> >http://www.tobit.co.uk/mailman/listinfo/dxspider-support
>> >
>> >
>> >
>> Hi
>>
>> I had the same problem , until i realized my mistake,
>>
>> I just left the DXcluster (spider) as it was default, the copied
>> listeners.pm to the correct place and told
>> listeners.pm to listen on Port 8000, then i also made a entry in my
>> firewall for the same.
>
> As a matter of interest: why are people using port 8000 (rather than the
> default of 7300)?
>
> Is there something here that I ought to know about?
>
> Dirk G1TLH
>
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support
>