[Dxspider-support] New install problems
Andy Scott
radio at andelscott.co.uk
Sun Jul 8 15:58:36 CEST 2007
In message <mailman.1.1183888802.14487.dxspider-support at dxcluster.org>,
dxspider-support-request at dxcluster.org writes
> set/debug chanerr
> Then tell us what it says.
Ah - progress. I'll take it that "^PCPROT: unknown protocol" is not
what we want to see..... It is output after each incoming message or
spot. E.g.:
1183892357^DXChannel GB7DJK created (3)
1183892357^<- O GB7DJK telnet
1183892357^-> B GB7DJK 0
1183892357^-> E GB7DJK 0
1183892357^GB7DJK channel func state 0 -> init
1183892357^<- I GB7DJK GB7IPF
1183892357^PCPROT: unknown protocol
1183892357^<- I GB7DJK *** Connected to GB7DJK, Graffham, West Sussex
1183892357^PCPROT: unknown protocol
1183892357^<- I GB7DJK Hello Andy, this is GB7DJK in Graffham, West
Sussex
1183892357^PCPROT: unknown protocol
1183892357^<- I GB7DJK running DXSpider V1.54 build 0.107
1183892357^PCPROT: unknown protocol
...And so on.
...Looks like the $pcno (PCxx codes) is not 'defined' here then (or not
correctly recovered from the incoming message, but that seems less
likely). I did 'load/messages' just in case, but seems this is
irrelevant here.
Where to now?
--
Andy
More information about the Dxspider-support
mailing list