[Dxspider-support] A new version...

[Paul Pescitelli]

I put a fresh installation on a different box. I connect to wr3d just
fine, see the spots come across thru the console but no spots show up
thru the client.

ideas ?

Paul

On 6/21/07, Bob Nielsen <nielsen at oz.net> wrote:
>
> On Jun 21, 2007, at 2:56 PM, Dirk Koopman wrote:
>
> <snip>
>
> >>> You are now connected
> >>
> >> Yes (although I just disconnected).  If I set/isolate wr3d, will it
> >> still have benefits?  I don't want to send large node lists
> >> downstream (an AR-Cluster node down the line has some slow r.f.
> >> connections and they can choke on large amounts of data).
> >>
> >
> > I would set/isolate or just acc/route call n7xy (or by_dxcc w) your
> > ARC
> > link.
> >
>
> I used set/isolate and all looks fine.  Thanks.
>
> I notice that sh/mydx now uses the 'sh/fdx' syntax.  Also, when I do
> 'sh/node' it gives a wrong version for the connected node (on a cc-
> node also, so it has probably been that way for a while):
>
> sh/node
> Node Call   Sort    Version
> W7DX        ARClus  5-4..99
> N7XY        Spider  1.54
> WR3D        Spider  54.54 build: 0.58
> VE7CC-1     Spider  54.52 build: 61.504
>
>
> Bob N7XY
>
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://mailman.tobit.co.uk/mailman/listinfo/dxspider-support
>


-- 
73 - Paul    K4UJ
BS7H, FS, KP2, KP4, PJ6, PJ7,VP2E, ZF2UJ
==============================
http://www.dx-is.com  USA Spiderbeam Distributor
http://www.dx-is.org
Skype: dx.k4uj
==============================