<div dir="auto">I've been running the latest Ubuntu version for quite a while, with DXSpider v1.57 build 517, perl v5.34.0<div dir="auto"><br></div><div dir="auto">I saw several nodes over the weekend had updated to v1.57 build 519, so after the BARTG contest ended last night I tried updating myself. Normally, Kin's check_build tool does the job effectively. However, when I ran the tool it froze up and hadn't completed in 2 minutes. So, I hit Ctrl-C to abort. I rebooted the computer and tried Kin's tool again, with the same result. At first, I suspected the tool was malfunctioning. But, when I tried to do a manual update, I was getting nothing back after issuing "git pull". I've done many manual updates this way. None of this is new to me or my node configuration.</div><div dir="auto"><br></div><div dir="auto">su - sysop [password]</div><div dir="auto">cd /spider</div><div dir="auto">git reset --hard</div><div dir="auto">git pull</div><div dir="auto"><br></div><div dir="auto">I get the correct response from the 'git reset --hard" command, even "git describe --long". I'm no linux guru, so even tried re-installing git (apt install git). Don't know enough to figure this out on my own.</div><div dir="auto"><br></div><div dir="auto">It appears something specific to my node since nobody else has mentioned this issue. Any ideas? Is there another way to force a spider update? Thanks in advance.</div><div dir="auto"><br></div><div dir="auto">73, Steve - AA4U </div><div dir="auto"><br></div></div>