[Dxspider-support] KPC3

[Colin Harris]

If it helps the KPC3 has three settings.

1 is the default from the factory and is called NEWUSER
2 is the next stage which you set so that parameters can be
changed
   called TERM  ( both preceeded by INT  or INTERFACE ).
3 is the KISS setting. After assuring that the speed of talk
to the computer has been set as required then INTERFACE KISS
can be set.

It should be noted that the default from the factory is 300
baud

This is for the KPC3 ( not plus ).. The backup battery will
hold kiss mode unless the battery is low or dead . On some
occasions I have found the KPC3 can be tripped out of Kiss
during some reboot proceedures.  ( With BPQ ( and AX235
under Linux) there should be no need to put the tnc into
kiss and take it out at shutdown or on the occasion of a
reboot ). Just place it in kiss using something like PAKET5
or other software then let the software supply the parms.
                Don't know about AGW. Never used it !

- Regards Colin

----- Original Message -----
From: Dave Hawes <dave.n3rd at comcast.net>
To: <dxspider-support at dxcluster.org>
Sent: Saturday, December 14, 2002 8:02 PM
Subject: Re: [Dxspider-support] KPC3