[Dxspider-support] Telnet question

Anthony J. Cioffi n2ki at amsat.org
Sun Feb 24 23:28:04 GMT 2002


Bruce,

    For the LinkSys router setup , go into the administration mode.
Under the Advanced - Forwarding tab you need to configure the IP address
of the DX CLuster computer as well as the port range.  So under where it
says "Service Port Range" type in 7300 in both boxes.  "Protocol" should
be "BOTH" and then enter in the last digits of the ip address on the
Cluster computer.   All this is correct assuming that when you log into
the router administration, the software setup is the same.

    After you configure the router, the you have to set up the
"listeners. pm" file in Spider\Local.    I will send you a copy of my
listener file direct.



Tony - N2KI







More information about the Dxspider-support mailing list