[Dxspider-support] Telnet question

[Bruce Marshall]

Tony:

Thanks for the info.  I'm not sure I have the IP addresses configured
correctly on my network.  Can I call you on the phone about this setup?

Bruce

----- Original Message -----
From: "Anthony J. Cioffi" <n2ki at amsat.org>
To: <dxspider-support at dxcluster.org>
Sent: Sunday, February 24, 2002 6:28 PM
Subject: Re: [Dxspider-support] Telnet question


> Bruce,
>
>     For the LinkSys router setup , go into the administration mode.
> Under the Advanced - Forwarding tab you need to configure the IP address
> of the DX CLuster computer as well as the port range.  So under where it
> says "Service Port Range" type in 7300 in both boxes.  "Protocol" should
> be "BOTH" and then enter in the last digits of the ip address on the
> Cluster computer.   All this is correct assuming that when you log into
> the router administration, the software setup is the same.
>
>     After you configure the router, the you have to set up the
> "listeners. pm" file in Spider\Local.    I will send you a copy of my
> listener file direct.
>
>
>
> Tony - N2KI
>
>
>
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support