[Dxspider-support] AX25

[Jim Johnson]

Hello All, 

Well I agree with Rene about the KPC-3.  I have been using one for 
several years and it occassionally comes out of KISS mode.  

When changing over the node here from PacketCluster(TM) to 
DXSpider(TM), I used another computer and pacterm to put the KPC-3 
into KISS mode with command INT (for INTERFACE) KISS.  You have to 
turn the (TNC) power off and then back on to make the setting take 
affect.  

By the way, to take it out of KISS mode, using Pacterm hold down the Alt 
key and enter 192 then 255 and then 192 and you should get the 
Kantronic banner.   

Hopefully this helps!

On 14 Jul 02, at 17:47, Rene Olsen wrote:

> Hi Tony.
> 
> On 14 Jul 2002 at 11:32, Tony wrote:
> 
> > Having trouble setting up the interface for a TNC.
> > the TNC is a KPC-3
> > 
> > can someone help with the correct entries to interface this TNC
> 
> I am not sure if it is possible to use it in command mode. The easiest way
> is probably to switch the KPC3 into KISS mode. That works just fine, and is
> easy to set up.
> 
> The only problem with this, is that the KPC3 can sometimes slip out of KISS
> mode, and then you have to set it in KISS mode again. I think it is
> possible to get an EPROM image that makes it run in KISS mode always.
> 
> I hope this gets you a bit further.
> 
> Vy 73 de Rene / OZ1LQH
> 
> 
> 
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support
> 



Jim Johnson, Melbourne, Florida
jim at kc4hw.net - http://www.kc4hw.net
DXCluster RF Connection: 144.97
Telnet://kc4hw.homelinux.net:8000