[Dxspider-support] Spider <-> SV2AGW Packet Engine

[Ian Morrison]

Also a lot of problems are caused by squelch. If you can use the DCD
software control in the TNC of make sure the squelch is set so the rx led is
out with no signal.

It should work fine.

GL, Ian
VE3IEM

----- Original Message ----- 
From: "charlie carroll" <k1xx at ptcnh.net>
To: "The DXSpider Support list" <dxspider-support at dxcluster.org>
Sent: August 5, 2003 12:11 AM
Subject: Re: [Dxspider-support] Spider <-> SV2AGW Packet Engine


> Charlie:
> There are 2 flavors of the KPC3.  You might try the other version.  Most
> of the problems I've hard with KPC3 is due to the TNC NOT being in the
> KISS mode.
> Tnc Type - KPC3+
>                  Tnc Sub Type - XKISS (Checksum)
>                  IniKiss1 - XKCH ON
>                  IniKiss2 - INTFACE XKISS
>                  IniKiss3 - RESET
>
> Tnc Type - KPC3
>                  Tnc Sub Type - KISS Simple
>                  IniKiss1 - <blank>
>                  IniKiss2 - INTFACE KISS
>                  IniKiss3 - RESET
>
> FWIW, there is another DXSpider node in Cumberland, RI.
>
> 73 charlie, k1xx
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support
>