[Dxspider-support] Connecting to nodes...
Dirk Koopman
djk at tobit.co.uk
Sat Feb 14 12:29:48 GMT 2004
You have to ask me first :-)
What node callsign are you going to use?
Dirk G1TLH
On Sat, 2004-02-14 at 04:25, Rod Taylor wrote:
> Hello to all,
>
> I now have my DXSpider cluster running and can successfully connect to it via
> telnet (local at the moment) and via vhf/uhf TNCs. I would now like to
> connect to one or two other clusters to start getting DX data. On reading the
> manual and following the instructions I am successfully connecting to gb7baa
> and wr3d via telnet sessions. However, the connections don't seem to do
> anything and I am disconnected after a few moments with the message "Too many
> concurrent errors, you are being disconnected". (The script I use is below).
> Is there a command I am supposed to enter to start getting DX data (and
> forwarding any from me)?
>
> Script....
> timeout 15
> connect telnet gb7baa.com 7300
> "login" "vk3cne-0"
>
>
> Any suggestions or directions to relevant documentation would be greatly
> appreciated.
>
> 73's, Rod VK3XRW.
>
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support
--
Please Note: Some Quantum Physics Theories Suggest That When the
Consumer Is Not Directly Observing This Message, It May Cease to
Exist or Will Exist Only in a Vague and Undetermined State.
More information about the Dxspider-support
mailing list