[Dxspider-support] Invalid Command on Node Connect

[Lee Sawkins]

Hi Roger

I think your problem is that you are confusing VE7CC and VE7CC-1 and
also PA4JJ and PA4JJ-1.  You must have exactly the correct call in all
the proper places.  Close is not good enough.

If you are connected to PA4JJ-1, you will not be talking to PA4JJ as per
the example you gave.

Lee VE7CC

Roger Martin wrote:
> 
> Hey everyone
> 
> 
> 
> I have tried a partner node connection between my node K5RLM-2 and
> VE7CC and now I am trying with Jan?s PA4JJ node and both get the same
> error. My node connects as it should but then gives errors stating:
> 
> 
> 
> DXCommand
> 
> Cmd: invalid characters in ?PC16^DL6IP^H97^
> 
> PA4JJ invalid command
> 
> 
> 
> Then after a few of these errors it disconnects due to excess errors.
> I also have WR3D and W1NR connected as nodes and they both work fine
> and have since the day I connected to them. I am fairly pc savy but
> not DXCluster savy at all. I think the problem is on my end but not
> sure where to start. It is a windows 2003 box and I already have done
> the set/spider pa4jj-1 command per Jan?s request. Any suggestions or
> comments would help
> 
>     ---------------------------------------------------------------
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://mailman.tobit.co.uk/mailman/listinfo/dxspider-support