[Dxspider-support] "git pull" issue?

[dxcluster]

Did you try sudo reboot?
That helped me
73
Jan
PA4JJ

Op 20-3-2023 om 18:48 schreef Stephen Carroll via Dxspider-support:
> I've been running the latest Ubuntu version for quite a while, with 
> DXSpider v1.57 build 517, perl v5.34.0
>
> I saw several nodes over the weekend had updated to v1.57 build 519, 
> so after the BARTG contest ended last night I tried updating myself. 
> Normally, Kin's check_build tool does the job effectively. However, 
> when I ran the tool it froze up and hadn't completed in 2 minutes. So, 
> I hit Ctrl-C to abort. I rebooted the computer and tried Kin's tool 
> again, with the same result. At first, I suspected the tool was 
> malfunctioning. But, when I tried to do a manual update, I was getting 
> nothing back after issuing "git pull". I've done many manual updates 
> this way. None of this is new to me or my node configuration.
>
> su - sysop [password]
> cd /spider
> git reset --hard
> git pull
>
> I get the correct response from the 'git reset --hard" command, even 
> "git describe --long". I'm no linux guru, so even tried re-installing 
> git (apt install git). Don't know enough to figure this out on my own.
>
> It appears something specific to my node since nobody else has 
> mentioned this issue. Any ideas? Is there another way to force a 
> spider update? Thanks in advance.
>
> 73, Steve - AA4U
>
>
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at tobit.co.uk
> https://mailman.tobit.co.uk/mailman/listinfo/dxspider-support