[Dxspider-support] sh/dx,max number of spots displayed

[Roland Huysentruyt,ON6HH]

Ok Dirk
Tnx very much .
It works fine .ON0DXK is a 600 Mhz and 128 Mb ram .
I found it worked also changing this parameter in  /spider/perl/Spots.pm  but
I knew this was not the good way to do it hi !
73
Roland
----------------------------------------------------------------------------
Roland Huysentruyt,Beatrijslaan 28,B 8870   IZEGEM , BELGIUM 
tel  (32) (0) 51 303000  email : on6hh at yucom.be    on6hh at qsl.net
packetmail on6hh at on0ck.wvl.bel.eu



> On Sat, 2001-09-08 at 17:55, Roland Huysentruyt,ON6HH wrote:
> > Hi
> > 
> > How to adjust the max number of lines displayed with f.e. the "sh/dx <number>" command ?
> > Now it is fixed to 50 max.
> > 
> 
> Currently the only way to do it permanently is a bit complicated.
> 
> 1) Copy /spider/perl/Local.pm to /spider/local
> 2) edit it and on line 26 there is a definition of 'sub init'
> 3) between the { on the next line and the } a couple of lines later:-
> 
> {
> $Spot::maxspots = 100;
> }
> 
> 4) to change the maximum to 100, obviously you can change it to any
> number you like, but I would STRONGLY suggest no more than about 250 or
> so unless you have a really fast machine.
> 
> 5) then restart the node.
> 
> Dirk
> 
> 
> _______________________________________________
> Dxspider-support mailing list
> Dxspider-support at dxcluster.org
> http://www.tobit.co.uk/mailman/listinfo/dxspider-support