[Dxspider-support] Incomplete output to RF linked Stations

[George Lloyd]

Funny that because I've had users complain of the same thing and I'm running 
a linux setup. I also cannot recreate it locally.


On Wednesday 16 January 2002  5:53 pm, you wrote:
> Hi,
>
> Sorry if this is a duplicate of a previous post - I am relatively new to
> the list, and did not stumble accross anything like it in the part of the
> archives I checked.
>
> Setup:
> I am running a reasonably current build of 1.49 in a Windows environment,
> using the SV2AGW packet engine to connect to a PK-232 running KISS simple
> protocol out to 2 meters. I have no connections to other nodes at this
> point, so it is a pretty basic simple system. My users are now seeing a
> problem where they will sometimes connect to the cluster and begin to
> display information (sh/dx, read a message, etc.) and then the information
> stops displaying, as if the system is locked up. I have not been able to
> duplicate the problem locally, even when using a spare TNC and RF
> connecting to the cluster using an HT. I do not see any error messages on
> my end, and it appears as if the Spider sofftware thinks the lines have
> been sent out, but they fail to display at the other end. This has occured
> with 2 separate systems (the K6-233 based system I started with, and a
> P5-133 system I built from junk to run as a dedicated cluster computer
> only), and multiple users. Any ideas? Is this a Spider issue or a packet
> engine issue? Anyone seen this one before?
>

-- 
G.B. Lloyd
g.lloyd at essexpkt.co.uk
www.essexpkt.co.uk 
For the home of NNA BBS software