[Dxspider-support] SEt/ISOlate
Hank Kohl K8DD
k8dd at arrl.net
Fri Jan 24 15:40:05 GMT 2003
Is anyone using SEt/ISOlate?
If I understand what I think I read ..... if I connect to two clusters (in
my case one AR K8NA and one AK1A W8BAD) after having done a set/isolate on
both of them
Show/Isolate gives me:
K8NA
W8BAD
2 records
DX spot comes from K8NA, goes to W8BAD and my users.
The same DX spot comes back from W8BAD, but is a duplicate spot and does
not go to the users or K8NA.
Seems to me both nodes should be isolated from each other and spots should
not pass from one to the other? I'm not sure where spots from my cluster
go ... to both or neither. Haven't tested that yet.
73 Hank K8DD
DX Spider Cluster version 1.51 (build 57.191) on MSWin32
Copyright (c) 1998-2003 Dirk Koopman G1TLH
*/ Hank Kohl K8DD k8dd at arrl.net
*/ ARRL TS http://www.qsl.net/k8dd
*/ MI-QRP - Vice Pres. QRP-ARCI - Director
*/
If God intended you to be on single sideband, he would have given you only
one nostril.
- Steve, K2PTS
More information about the Dxspider-support
mailing list